Copy of Programming Instructions V3 Liftmaster Chamberlain and Craftsman

 

Programming Instructions:

 

  1. Start with your door/gate closed. Check the color of your learn button behind the door opener motor panel.

 

  1. Press and hold buttons 1 and 2 on the CycleOpen remote at the same time until the LED indicator flashes 4 times and then goes off. Take the next step within 8 seconds.

 

 

  1. Press and release the remote control button you wish to use the number of times that corresponds with the garage door opener type.

 

  1. Press any button other than the button that you are programing to lock in the code.

 

 

# of presses

Garage door opener type

1

Security+2.0 (Yellow Learning Button)

2

315MHz Security+ (Purple Learning Button )

3

390MHz Security+ (Red or Orange Learning Button )

4

390MHz Billion Code (Green Learning Button)



For example: if you want to set button 1 to be a Yellow Learn button (Security+2.0) type, press and release button 1 one time, and then press and release any other button (2 thru 4) one time to lock in the code.

If you want to set button 2 to be a Purple Learn button (315MHz Security+), press and release button 2 two times, then press and release any other button (1, 3, or 4) one time to lock the code.

 

  1. Locate the Learn/Teach/Program button (usually located on the back or side of the unit sometimes behind a lens cover) and press it for about 2 seconds but less than 4 (pressing for 5 seconds can delete the openers memory!).

 

 

  1. Press the newly programmed button on the CycleOpen remote until the opener either blinks or operates.

Programming is now complete. To duplicate a second button, repeat the steps starting with Step 1.

 

 

Installation Instructions:

 

Step 1.  Choose a safe location on the handlebars of your motorcycle or bike in which to mount the opener.

 

Step 2.  Place the clamp on the underside of the handlebars making sure the “TOP” is at the top of your handlebar. Place the CycleOpen remote on top and angle the remote at the desired angle around the handlebar.

 

Step 3. Secure the opener by using the provided torx security wrench to tighten the two mounting screws. Gently tighten them one at a time to secure the device in place. Start with one screw and then proceed to the other, alternating between them until both are snug. It is crucial to exercise caution during this step. While it is essential to ensure CycleOpen is firmly attached, overtightening the screws can potentially damage the mounting system, therefore, we recommend tightening the screws just enough to securely fasten CycleOpen without applying excessive force.

 

Safety Precautions:  Do not operate or adjust the opener while riding.  CycleOpen assumes no liability for safety of the rider.  CycleOpen is not responsible for any damages caused to your motorcycle or bike due to the installation or use of this opener.

 

Battery Replacement:

 

The CycleOpen remote uses a 3-volt battery type CR2032.

 

Battery replacement does not affect the existing programming.

 

Step 1.  Using the provided torx security wrench, remove the two mounting screws to release the clamp so the opener can be removed from the handlebar.

 

Step 2.  Unscrew the four retaining screws on the back of the remote.

 

Step 3.  Remove the old battery and replace it with a new one.

 

Step 4.  Reassemble.